Sorry, out of order. This was done before the skinning, I just forgot to post.
Before we get the cement poured, we need to stub in the electrical. We are ‘splicing into the barn power for this:
And then the cement was poured:
New Shop – Cement
Tag: shop
Got the Shop Skinned
Here is a little stop motion:
Really quick post, Got the framing done!
The New Shop Is Coming – Site Prep!
Started by getting the site nice and level with some dirt:
then added 6-8 inches of crushed concrete:
Ready for framing!
Paint Booth Setup
I wanted to build a paint booth for the shop. I wanted it to help keep over spray down and provide at least a little ventilation. Here is what I cam up with.
I had a 4×8 sheet of hard board from another project. I measured everything out and cut it up:
In the back panel I drilled out some 2 and 3 inch holes in a 20×20 square. The same size as an air filter:
I then made a frame to hold a 20×20 AC filter. Again using scrap I had laying around:
I used Gorilla tape to hold it all together. The hard board is too thin to nail and if I needed to, I could cut the tape and lay it down.
Back Side:
Lastly, I added some lights and a lazy Suzann:
Portable Air Regulator/Dryer
I wanted to make a portable air dryer/regulator for use with my paint booth, air brush or any other system that could and would move around my shop. Here is what I came up with:
Made a tee with scrap pine 1×6, glued and screwed.
Then added Harbor Freight Dryer/Regulator and coil line. Quick and easy, gets the job done.
Sandpaper Storage Box
Wanted to make a box to hold my sandpaper. Nothing fancy, just quick
Using ½ ply I ran rabbits along the top and bottom and and ¼ inch slots every inch. Glued and tacked it all together. I am using the ratchet clamp for the first time:
Worked pretty good!
Sealed it up:
Cut and slid in some ¼ inch hard board I had:
Marked and ready to go:
You must be logged in to post a comment.