Tag: Woodworking

Paint Booth Setup

I wanted to build a paint booth for the shop. I wanted it to help keep over spray down and provide at least a little ventilation. Here is what I cam up with.

I had a 4×8 sheet of hard board from another project. I measured everything out and cut it up:

In the back panel I drilled out some 2 and 3 inch holes in a 20×20 square. The same size as an air filter:

I then made a frame to hold a 20×20 AC filter. Again using scrap I had laying around:

I used Gorilla tape to hold it all together. The hard board is too thin to nail and if I needed to, I could cut the tape and lay it down.

Back Side:

Lastly, I added some lights and a lazy Suzann:

Sandpaper Storage Box

Wanted to make a box to hold my sandpaper. Nothing fancy, just quick

Using ½ ply I ran rabbits along the top and bottom and and ¼ inch slots every inch. Glued and tacked it all together. I am using the ratchet clamp for the first time:

Worked pretty good!

Sealed it up:

Cut and slid in some ¼ inch hard board I had:

Marked and ready to go: