I made a new DIY Drill Press table to replace the very small one that came with it.
First thing I did was cut a piece of ¾ inch plywood 24 x 18 inches, cut a notch in the back for the support tube and drop in 4 carriage bolts spaced to fit through the existing table. I used the wing nuts and washers to temporary hold them in place.
Counter sunk and glued in place
Cut and glued the top plate to it.
Also notched and cut out a square area for a sacrificial block.
Sanded and added the T-Track
Sealed it up:
Created a base plate and added some knobs I had laying around
Added the fence, and she is done!
You must be logged in to post a comment.