I wanted to build a paint booth for the shop. I wanted it to help keep over spray down and provide at least a little ventilation. Here is what I cam up with.
I had a 4×8 sheet of hard board from another project. I measured everything out and cut it up:
In the back panel I drilled out some 2 and 3 inch holes in a 20×20 square. The same size as an air filter:
I then made a frame to hold a 20×20 AC filter. Again using scrap I had laying around:
I used Gorilla tape to hold it all together. The hard board is too thin to nail and if I needed to, I could cut the tape and lay it down.
Back Side:
Lastly, I added some lights and a lazy Suzann:
