Lee Load Master Mount from Becks Armory

First off Richard Beck richard@becksarmory.com at Becks Armory is a great guy to work with. The mounts are hand crafted in America with quality materials. All mounting hardware except the wood screws was also included. The wood screws to mount the rear bracket to my bench are not included because the thickness of my bench was unknown to Richard. My mounts were packed VERY well and received quickly after shipment.

Richard also said he can create custom mounts based on the same design. I just need to send him the measurements. I might get one made for my RCBS Accessory Base Plate. That will be a separate post 🙂

Here is a link to directly to the bracket I got: . http://becksarmory.com/product/lee-load-master-mounting-kit/

Below is a quick post of what I did to get it mounted.

First thing I did was mount the brace. I used ½ inch wood screws to get the job done.

Then I drilled the bottom 2 holes from back to front.

I held the mount in front and placed the 2 bottom bolts into the before mentioned holes. Made sure it was level and marked the top 2 holes as shown above and drilled them out. Then mounted it up.

When I do it again, I will make a jig with the hole pattern and drill the holes out that way. Don’t know why I didn’t think of that till after the fact.

Here is a shot with the press mounted.